NEC Electra Elite IPK II System Hardware Manual page 49

Electra Elite IPK II
___________________________________________________________________________________
Table 3-3 Maximum System Capacities for Trunk Interface ETUs (Continued)
Trunk Interface
ETUs
TLI (2)-U( ) ETU
Note 1: Calculating maximum capacity is based on the system having a minimum of eight Electronic Station Interface
(ESI) ports, four Trunk ports and a PKUII-U Unit installed.
Note 2: When 2-port Trunk Interface ETUs are installed, the system uses four ports from its maximum port capacity.
Note 3: With the Electra Elite IPK II Expanded Port Package, a maximum of 14 COIB(4)-U( ) ETUs can be installed as
COID(4)-U( ) ETUs.
Note 4: Refer to the KSU Power-Based Calculator Chart.
Note 5: Firmware 5.0 or higher is required.
Note 6: Firmware 3.0 or higher is required.
Note 7: The first four DTI/PRI ETUs are assigned 24 Channels, the next six are assigned 16 Channels, and the eleventh
is assigned eight channels.
___________________________________________________________________________________
System Hardware Manual
Description
This 2-Port Tie Line Interface ETU
supports the termination and operation
of two E&M tie lines (4-wire, type I and
type V, and 10/20 pps Dial Pulse or
DTMF). Immediate, wink start, second
dial tone, and delay dial signaling can
be combined on this ETU. This ETU is
installed in slots S1~S8 in any
B64-U20 KSU. The maximum number
depends on other trunk ETUs installed.
This ETU shares the total number of
CO/PBX lines in the system.
Maximum Capacities
Basic Port Expanded
Package Port Package
14 23
Document Revision 3
Notes
Note 2
3 - 15