NEC Electra Elite IPK II System Hardware Manual page 536

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
11 - 32
4. Remove the shaded base plate knockout shown on
Figure 11-39 Removing the
Figure 11-39 Removing the Knockout
5. Assemble the base plate and base cover.
6. As illustrated in
Wall, attach the base plate and base cover assembly (wide end
down) to the posts on the locally provided and installed wall
plate. Place locally provided screws in the nodes on the base
plate and secure the assembly to the wall.
Posts
Figure 11-40 Attaching the Base Plate to the Wall
Installing Electra Elite Optional Terminal Equipment
Knockout.
Figure 11-40 Attaching the Base Plate to the
Electra Elite IPK II
Nodes
Nodes