External Page; Connecting To The Pgd(2)-U10 Adp - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
6.6
6.7
___________________________________________________________________________________
System Hardware Manual

External Page

Two external page zone/door box circuits are provided by each PGD(2)-U10
ADP installed. Each Door Box/external page circuit provides a dry relay
contact. The external page speakers provided by the
1~8. The relays on the
External in the Electra Elite IPK II Features and Specifications Manual for
additional details.
A PGD(2)-U10 ADP circuit used for External Paging cannot be used for an
analog Door Box.

Connecting to the PGD(2)-U10 ADP

1. Make sure the jumper in the
correctly. (Refer to
2. If a line cord was not previously connected to the
complete Steps 3~6. Otherwise, skip to Step 7.
3. Install a modular jack for each
station cable from the crossconnect block to a modular jack. Ground the
unused pair.
4. Terminate the extension leads to GRN/RED of the modular jack.
Terminate the unused leads to the jack.
5. Install bridging clips as required.
6. Plug a modular line cord from the mod jack to the CN1 connector on the
PGD(2)-U10 ADP
7. Connect the two-conductor station cable from the CN5 connector in the
PGD(2)-U10 ADP
are numbered 1~8. Refer to Paging,
PGD(2)-U10 ADP
PGD(2)-U10 ADP
Figure 7-6 Jumper
PGD(2)-U10 ADP
.
to the external relay/external page.
Document Revision 3
PGD(2)-U10 ADP
for the channel is set
Settings).
PGD(2)-U10 ADP
. Run one-pair 24 AWG
are
,
7 - 15