Installation Procedure; Attaching Or Removing Faceplate And Desi Printer Sheet; Adjusting Angle Of Tilt Legs - NEC Univerge SV9500 User Manual

INSTALLATION PROCEDURE

ATTACHING OR REMOVING
FACEPLATE AND DESI PRINTER
SHEET
REMOVING FACEPLATE AND
DESI PRINTER SHEET
Remove DESI Printer Sheet with following ways.
1.
Use the small notch at the lower right corner of
the terminal to lift the Faceplate up.
2.
Remove the Faceplate.
3.
Remove the DESI Printer Sheet.
(1)
(2)
(1) Line Key Panel
(2) Face Plate
(3) DESI Printer Sheet
ATTACHING FACEPLATE AND
DESI PRINTER SHEET
1.
After replacing the DESI Printer Sheet on the
terminal, attach the Faceplate.
2.
At each corner, press the locking pin back into
place.
(1)
(2)
(1) Line Key Panel
(2) Face Plate
(3) DESI Printer Sheet

ADJUSTING ANGLE OF TILT LEGS

The height can be adjusted by moving the legs
attached to the bottom of the terminal.
(1)
(2)
(3)
(4)
(5)
(3)
RAISING TILT LEGS
1.
Turn the terminal over (key side down).
2.
Raise Tilt Legs to desired height.
(3)
3.
Turn the terminal over (key side up).
15
INTRODUCTION
Please attach the Faceplate securely.
If not, the terminal will not operate
properly because a key is possibly
being pushed by the Faceplate.
(1) First Position
(2) Second Position
(3) Third Position
(4) Forth Position
(5) Fifth Position
Tilt Leg