General Information; Company Notification - NEC Electra Elite IPK II System Hardware Manual

Regulatory Information
___________________________________________________________________________________
S 1 G
ECTION
Established Federal Communications Commission (FCC) rules permit this telephone
system to be directly connected to the telephone network. A jack is provided by the
telephone company. Jacks for this type of customer provided equipment are not
provided on party lines or coin lines.
The telephone company may change technical operations and procedures. When
such changes affect the compatibility or use of the Electra Elite IPK II system, the
telephone company is required to give adequate notice of the changes.
S 2 C
ECTION OMPANY
Before connecting this telephone system to the telephone network, the following
information must be provided to the telephone company:
1.
2.
___________________________________________________________________________________
System Hardware Manual
I
ENERAL NFORMATION
N
OTIFICATION
Your telephone Number.
FCC registration number:
When the system is to be installed as a Key Function system (no dial
access to Trunk Groups/Route Advance Blocks), use the following
number:
NIFMUL-43074-KF-E
When the system is to be installed as a Multifunction system, use the
following number:
NIFMUL-43076-MF-E
When the system is to be installed as a PBX system, use the following
number:
NIFMUL-43075-PF-E
Ringer Equivalence Number (REN): 2.0B
USOC jacks required: RJ21X and RJ2GX
Chapter 1
1 - 1