Electra Elite IPK II
___________________________________________________________________________________
___________________________________________________________________________________
System Hardware Manual
8.4.2
Installation
Basic Port Package
Only one CCH(4)-U( ) ETU can be installed in any interface slot.
Expanded Port Package
Only one CCH(4)-U( ) ETU can be installed in any interface slot.
8.4.3
Switch Settings
Refer to
Table 6-51 CCH(4)-U( ) ETU Default Switch
Table 6-51 CCH(4)-U( ) ETU Default Switch Settings
Switch
SW1
Momentary Switch
Resets the CCH ETU. When this switch is pressed, all
K-CCIS users connected to the CCH ETU are interrupted.
Use this switch only after all other options have failed.
SW2–1
Off:
On:
SW2–2
Off:
On:
SW2–3
Off:
On:
SW2–4
Off:
On:
8.4.4
LED Indications
Refer to
Table 6-52 CCH(4)-U( ) ETU LED
LED
Description
1
Link Status for
2
Link Status for
3
Link Status for
4
Link Status for
Setting/Description
Normal Operation (Default)
Test Mode
Boot from Flash Memory (Default)
Boot from E-PROM (IC30)
Normal Operation (Default)
Test Mode
Watch Dog Timer On (Default)
Watch Dog Timer Off
Table 6-52 CCH(4)-U( ) ETU LED Indications
On
Layer 2: Up
CCH1
Layer 2: Up
CCH2
Layer 2: Up
CCH3
Layer 2: Up
CCH4
Document Revision 3
Settings.
Indications.
Flashing
Off
Not Used
Layer 2: Down
Not Used
Layer 2: Down
Not Used
Layer 2: Down
Not Used
Layer 2: Down
6 - 153