Led Indications; Setting Up Pgd(2)-U10 Adp Connections - NEC Electra Elite IPK II System Hardware Manual

Electra Elite IPK II
___________________________________________________________________________________
6.2
6.3
___________________________________________________________________________________
System Hardware Manual

LED Indications

LED
LED 1
LED 2

Setting Up PGD(2)-U10 ADP Connections

When the PGD(2)-U10 ADP is to be wall mounted, all the cable connections
should be made first.
For the module to ID correctly after setting the jumpers, set the circuit to zero
for the module port in Program 10-03-01 prior to connecting the line cord to
the PGD(2)-U10 ADP.
1. Remove the screw from the front of the PGD(2)-U10 ADP.
Figure 7-4 Remove Cover from PGD(2)-U10 ADP
2. Using a screwdriver, break out the plastic piece covering the cable hole.
Indication
Green LED Flashing green LED indicates dip switch
when CH1 in setting and programming for CH1 are in
use. conflict.
Green LED Flashing green LED indicates dip switch
when CH2 in setting and programming for CH2 are in
use. conflict.
Module
Document Revision 3
Note
7 - 5