Boot Up Sequence Status Identification; Installation - NEC Electra Elite IPK II System Hardware Manual

Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
6 - 168
Configuration
CCISoIP
ESI(8)-U( )
8.8.2

Boot Up Sequence Status Identification

Status of the IAD(8)-U( ) ETU during boot up is shown in
IAD(8)-U( ) ETU LED Boot Sequence
Table 6-63 IAD(8)-U( ) ETU LED Boot Sequence Indications
D8 D6 D4
State CH CH CH
1 2
1 Off Off Off
2 ON ON ON
3 Off Off Off
4 Off Off Off
5 Off Off Off
6 Off Off Off
* LIVE LED D12 also flashes when ETU is receiving power from the KSU.
8.8.3

Installation

This ETU can be installed in any KSU slot that supports the
applicable ETU simulated.
Basic Port Package
A maximum of three IAD(8)-U( ) ETUs can be installed in slots
S1~S8 when used as an ESI.
A maximum of six IAD(8)-U( ) ETUs can be installed in slots S1~S8
when used as a CCISoIP ETU.
Expanded Port Package
A maximum of 14 IAD(8)-U( ) ETUs can be installed in slots S1~S8
when used as an ESI.
Table 6-62 IAD(8)-U( ) Configurations
Installation slot
Port
Electra Elite IPK
s
8
8
D2 D7 D5
CH CH CH
3 4 5 6
Off Off Off
ON Off Off
Off Off Off
Off ON ON
Off Off Off
Off Off Off
Electra Elite IPK II
Application
II
S1~S8 CCISoIP ETU
S1~S8 Megaco Station ETU
Indications.
D3 D1
*D12
CH CH
LIVE
7 8
Off Off Flash
(from Cold Boot)
Off Off Flash
Off Off Flash
Off Off Flash
ON ON Flash
Off Off Flash
Installing ETUs (Circuit Cards)
Table 6-63
Approximate
Time
1 second
5 seconds
3 seconds
5 seconds
5 seconds
5 seconds