Document Revision 3
___________________________________________________________________________________
___________________________________________________________________________________
9 - 20
3.4.1
Installing the CT(A)-R Unit
The CT(A)-R Unit should be installed before connecting the PC and
before connecting the ESI port to the Multiline Terminal.
When wall mounting the Multiline Terminal, a WM-R Unit must be
used. Refer to
8-29.
1.
Prepare Multiline Terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation
on page
2.
Plug the tabs marked A and B into adapter slots, then snap the
tab on the other end of the adapter into the receptacle marked
C . Refer to
Terminal.
Installing Electra Elite IPK II Optional Terminal Equipment
Section 13 Wall Mounting Multiline Terminals on page
9-1.
Figure 9-21 Attaching the CT(A)-R Unit to the
Electra Elite IPK II