Preliminary Steps; Removing The Defective System Board - Fujitsu PRIMERGY TX1320 M1 Upgrade And Maintenance Manual

14.5.1 Preliminary steps

"Disabling BitLocker functionality" on page 73
Ê
"Disabling SVOM boot watchdog functionality" on page 74
Ê
"Locating the defective server" on page 44
Ê
"Shutting down the server" on page 52
Ê
"Disconnecting power cords" on page 53
Ê
Ê Disconnect all external cables.
"Opening the server" on page 55
Ê
"Removing the system fan module" on page 153
Ê

14.5.2 Removing the defective system board

Ê Remove all cables from the system board.
Ê Remove the following components from the system board:
– Heat sink: see section
I
Leave the processor on the defective board for now.
– Memory modules: refer to section
page 218
I
Ensure to take note of the memory modules' mounting positions
for reassembly.
– Expansion cards: refer to the section
page 178
I
Ensure to take note of the controllers' mounting positions and
cable connections for reassembly.
– UFM: refer to section
I
Remove the UFM spacer from the defective system board and
fasten it to the UFM with the UFM screw.
TX1320 M1
"Removing the processor heat sink" on page 225
"Removing the UFM" on page 288
Upgrade and Maintenance Manual
System board and components
"Removing memory modules" on
"Removing expansion cards" on
305