Removing The Defective System Board - Fujitsu PRIMERGY RX2540 M1 Upgrade And Maintenance Manual

14.7.2 Removing the defective system board

Ê Remove all cables from the system board.
Ê Remove the following components from the system board as shown in the
related sections:
– Heat sink: see
I
Leave the processor on the defective board for now.
– Memory modules: see section
page 282
I
Ensure to take note of the memory modules' mounting positions
for reassembly.
– Expansion cards: see section
I
Ensure to take note of the controllers' mounting positions and
cable connections for reassembly.
– UFM: see section
– DynamicLoM: module see section
on page 260
module.
RX2540 M1
section "Removing processor heat sinks" on page 311
"Removing expansion cards" on page 181
"Removing the UFM" on page 370
or the three screws that are installed in place of the LoM
Upgrade and Maintenance Manual
System board and components
"Removing memory modules" on
"Removing the DynamicLoM module"
401