Replacing A Riser Card - Fujitsu PRIMERGY RX1330 M5 Upgrade And Maintenance Manual

Expansion cards and backup units
Concluding steps
▶ Install the corresponding riser module, see
page 64.
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
▶ If applicable,
"Installing the front cover with lock" on page
▶
"Enabling replaced components in the BIOS" on page
▶ Inform the customer about changed WWN, MAC and SAS addresses, see
"Looking for MAC/WWN/GUID and SAS addresses" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page 85.
▶
"Updating expansion card firmware" on page
▶
"Resuming BitLocker functionality" on page
▶ If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card).
Configuration of network settings should be performed by the
customer. For more information, see
recovery".
▶ If applicable, restore LAN teaming configurations, see
upgrading LAN controllers" on page
9.5.5

Replacing a riser card

Field Replaceable Unit
(FRU)
Tools:
Phillips PH2 / (+) No. 2 screw driver
204
53.
57.
60.
93.
Upgrade and Maintenance Manual
"Installing a riser module" on
61.
81.
77.
86.
"Note on network settings
"After replacing or
Hardware: 5 minutes
88.
RX1330 M5