Installing An Expansion Card In Riser Module 2 - Fujitsu PRIMERGY RX2450 M1 Upgrade And Maintenance Manual

Expansion cards and riser cards
Concluding steps
▶ Install the riser module 1, see
▶
"Reassembling" on page
▶ If applicable, connect external cables to the expansion card.
▶
"Connecting the power cord" on page
▶
"Switching on the server" on page
9.3.4

Installing an expansion card in riser module 2

Upgrade and Repair Unit
(URU)
Tools: Phillips PH2 / (+) No. 2 screw driver
Preliminary steps
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove the riser module 2, see
Installing the expansion card in riser module 2
Figure 71: Removing the slot cover - example slot 1
110
"Installing the riser module 1" on page
44.
48.
49.
37.
"Removing the riser module 2" on page
Upgrade and Maintenance Manual
Hardware: 10 minutes
38.
39.
54.
52.
RX2450 M1