Reconfiguring The Backup Software Solution - Fujitsu PRIMERGY RX2530 M4 Upgrade And Maintenance Manual

Ê Save your changes and exit the BIOS.
I
Up to two Option ROMs can be activated in the BIOS at a time.
For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
When the enabled expansion card is initialized during the POST phase of the
boot sequence, a key combination is displayed temporarily to enter the firmware
of the expansion card.
Ê Press the displayed key combination.
Ê Modify the expansion card firmware options as desired.
Ê Save your changes and exit the firmware.
I
The option ROM of the expansion card can now be disabled in the BIOS.
Exception: If the expansion card controls a permanent boot device, the
Option ROM of the expansion card has to remain enabled.
5.2.5

Reconfiguring the backup software solution

I
This task only applies to Japan.
Disabling backup drives
Depending on the backup software solution, it may be necessary to disable or
delete the backup drive from the backup software drive list and reconfigure
backup jobs after completing the maintenance task.
I
More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
Re-enabling backup drives
If a backup drive has been disabled or deleted from the backup software drive
list as described in section
solution" on page
Ê Re-enable backup drives and revise backup software settings and cronjobs.
I
More information on suitable backup software solutions and related
documentation is available from the Fujitsu web pages.
RX2530 M4
"Verifying and configuring the backup software
80, it has to be re-enabled to complete the maintenance task.
Upgrade and Maintenance Manual
Basic software procedures
87