Table 25: Predefined Summer-Time Parameters - Edge-Core ECS4620-28P Cli Reference Manual

clock summer-time
(recurring)
Summer Time, or Daylight Savings Time (DST). Typically, clocks are adjusted
forward one hour at the start of spring and then adjusted backward in autumn.
◆
This command sets the summer-time time relative to the configured time zone.
To specify the time corresponding to your local time when summer time is in
effect, select the predefined summer-time time zone appropriate for your
location, or manually configure summer time if these predefined
configurations do not apply to your location (see
clock summer-time

Table 25: Predefined Summer-Time Parameters

Region Start Time, Day,
Week, & Month
Australia 00:00:00, Sunday,
Week 5 of October
Europe 00:00:00, Sunday,
Week 5 of March
New Zealand 00:00:00, Sunday,
Week 1 of October
USA 00:00:00, Sunday,
Week 2 of March
Example
The following example sets the Summer Time setting to use the predefined
settings for the European region.
Console(config)#clock summer-time MESZ predefined europe
Console(config)#
Related Commands
show sntp (178)
This command allows the user to manually configure the start, end, and offset
times of summer time (daylight savings time) for the switch on a recurring basis.
Use the no form to disable summer-time.
Syntax
clock summer-time name recurring b-week b-day b-month b-hour b-minute e-
week e-day e-month e-hour e-minute [offset]
no clock summer-time
name - Name of the timezone while summer time is in effect, usually an
acronym. (Range: 1-30 characters)
b-week - The week of the month when summer time will begin. (Range: 1-5)
Chapter 4
(recurring).
End Time, Day,
Week, & Month
23:59:59, Sunday,
Week 5 of March
23:59:59, Sunday,
Week 5 of October
23:59:59, Sunday,
Week 3 of March
23:59:59, Sunday,
Week 1 of November
– 185 –
| System Management Commands
clock summer-time (date)
Rel. Offset
60 min
60 min
60 min
60 min
Time
or