Mac-Address-Table Aging-Time - Edge-Core ECS4210-12P Reference Manual

mac-address-table
This command sets the aging time for entries in the address table. Use the no form
to restore the default aging time.
aging-time
Syntax
Default Setting
300 seconds
Command Mode
Global Configuration
Command Usage
The aging time is used to age out dynamically learned forwarding information.
Example
mac-address-table
This command enables MAC isolation globally on the switch. Use the no form to
mac-isolation disable this feature.
Syntax
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
◆
◆
mac-address-table aging-time seconds
no mac-address-table aging-time
seconds - Aging time. (Range: 6-7200 seconds; 0 to disable aging)
Console(config)#mac-address-table aging-time 100
Console(config)#
[no] mac-address-table mac-isolation
MAC address isolation provides tighter control over traffic passing from
downlink ports over the local network. Access for individual clients can be
restricted to uplink ports, or also to members within a shared community.
MAC address isolation is restricted to static MAC addresses, which must also
specify the isolation mode, using the
command.
– 425 –
Chapter 17
| Address Table Commands
mac-address-table static isolation