Suzuki Wagon R Manual page 1905

3D-2 FRONT SUSPENSION
The front suspension is the strut type independent suspension. The upper end of a strut is anchored to the vehi-
cle body by a strut support. The strut and strut support are isolated by a rubber mount. A strut bearing is also
installed a little lower to the rubber mount.
The lower end of the strut is connected to the upper end of a steering knuckle and lower end of knuckle is
attached to the stud of a ball joint which is incorporated in a unit with a suspension control arm. And connected
to this steering knuckle is the tie-rod end.
Thus, movement of the steering wheel is transmitted to the tie-rod end and then to the knuckle, eventually caus-
ing the wheel-and-tire to move. In this operation, with the movement of the knuckle, the strut also rotates by
means of the strut bearing and lower ball joint.
1. Strut assembly
2. Steering knuckle
General Description
3. Suspension control arm 5. Wheel bearing
4. Ball stud 6. Front wheel hub
7. Wheel
8. Wheel bolt
Tightening torque