Suzuki Wagon R Manual page 1915

3D-12 FRONT SUSPENSION
6) Install brake disc.
7) Tighten brake disc screws.
Tightening torque
Brake disc screw (a): 9 Nm (0.9
8) Install brake caliper/caliper carrier.
9) Tighten caliper carrier bolts to specified torque.
Tightening torque
Brake caliper carrier bolt (b): 95 N
10) Depress foot brake pedal and hold it there.
Tighten new drive shaft nut (1) to specified torque.
Tightening torque
Drive shaft nut (c): 175 N
11) Calk drive shaft nut as shown.
CAUTION:
Be careful while caulking nut so that no crack will occur
in caulked part of nut. Cracked nut must be replaced with
new one.
12) Install wheel and tighten wheel bolts to specified torque.
Tightening torque
·
Wheel bolt: 95 N m (9.5 kg-m, 69.0 lb-ft)
Suspension Control Arm / Bushing
Removal
1) Hoist vehicle and remove wheel referring to "Wheel
Removal" in Section 3F.
2) Remove split pin (12), stabilizer bar nut (10), washer (9) and
bushing (8).
3) Remove stabilizer bar mount bracket (right & left) bolts (5).
4) Remove ball stud bolt (2).
5) Remove suspension Control arm mounting bolt (6) and
washer.
6) Remove suspension control arm (7).
1. Stabilizer bar
2. Control arm ball stud bolt
3. Knuckle
4. Ball stud
5. Stabilizer bar bracket bolt
6. Control arm mounting bolt
7. Suspension control arm
kg-m, 6.5 lb-ft)
·
m (9.5 kg-m, 69.0 lb-ft)
·
m (17.5 kg-m, 127.0 lb-ft)
8. Stabilizer bar bushing
9. Washer
10. Stabilizer bar nut
11. Suspension control arm bushing:
Before installing, apply soap water.
12. Split pin
Tightening torque
Do not reuse.