Suzuki Wagon R Manual page 1917

3D-14 FRONT SUSPENSION
Brake caliper carrier bolt
Brake disk screw
Castle nut
Control arm ball stud bolt
Control arm mounting bolt
Drive shaft nut
Stabilizer bar bracket bolt
Strut bracket bolt
Strut support nut
Tie-rod end nut
Wheel bolt
3) Install ball stud (2) to knuckle (1). Align ball stud groove with
4) Install wheel and tighten wheel bolts to specified torque.
5) Lower hoist and vehicle in non-loaded condition, tighten con-
Tightening Torque Specifications
Fastening part
knuckle bolt hole as shown.
Then install ball stud bolt from the direction as shown.
Tighten control arm ball stud bolt to specified torque.
Tightening torque
Control arm ball stud bolt
·
(a): 60 N m (6.0 kg-m, 43.5 lb-ft)
Tightening torque
·
Wheel bolt (a): 95 N m (9.5 kg-m, 69.0 lb-ft)
trol arm mounting bolt (1) to specified torque.
Tightening torque
Control arm mounting bolt (a): 60 N
• Install stabilizer bar, referring to "Stabilizer Bar Installation" in
this section.
N•m
95
50
– 150
60
60
175
45
115
23
40
95
·
m (6.0 kg-m, 43.5 lb-ft)
Tightening torque
kg-m
9.5
9 0.9
5.0 15.0
–
6.0
6.0
17.5
4.5
11.5
2.3
4.0
9.5
lb-ft
69.0
6.5
36.5 108.5
–
43.5
43.5
127.0
32.5
83.5
17.0
29.0
69.0