Volkswagen Passat 1995 Official Factory Repair Manual page 3067

1st to 3rd gear clutch -K1- with turbine shaft, disassembling and assembling
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.38.3
Fig. 5 Checking that piston rings are correctly
located
There are two piston rings installed on the turbine
shaft inside the clutch housing.
- Make sure that ends of piston rings are hooked
together.
Fig. 6 Installing and hooking ends of piston
ring together
- Place piston ring in groove.
- To hook ends together press sides of ring in and
guide ends over one another.
- Do not twist piston ring out of groove on one side.
Page 6 of 6
38-12
12/6/2004