Volkswagen Passat 1995 Official Factory Repair Manual page 3351

Front Wheel Suspension, Shafts and Axle
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.40.1
Installing
- Remove remains of locking fluid from outer joint
and hub splines. (Splines must be free of oil and
grease).
- Apply locking fluid D 185 400 A2 to splines as
shown in illustration. Bead cross section approx. 3
mm.
- Install drive shaft.
- Connect ball joint to control arm.
- Install drive shaft to transmission flange shaft and
secure.
- Install 12-point nut to drive shaft and tighten.
Note:
To tighten 12-point nut we recommend the angle
measuring wrench VAG 1756 or equivalent.
Only loosen and tighten with vehicle standing on
its wheels (danger of accident).
Page 44 of 82
40-44
12/7/2004