Volkswagen Passat 1995 Official Factory Repair Manual page 3065

1st to 3rd gear clutch -K1- with turbine shaft, disassembling and assembling
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.38.3
Fig. 1 Removing and installing circlip
- Press piston cap with intermediate spring ring
down far enough for circlip (arrow) to be inserted in
groove.
Fig. 2 Installing thrust plate and plates onto
inner plate carrier
- Install thrust plate -a- with smooth side facing inner
plate and stepped side toward inner plate carrier.
- Install 3 inner plates -b- and 2 outer plates -c-.
- Insert supporting ring with step (arrow) after
installing thrust plate as well as inner and outer
plates.
Note:
Locate locating lugs correctly.
Installing corrugated washer and additional plates
in clutch housing Fig. 3 .
Page 4 of 6
38-10
12/6/2004