Volkswagen Passat 1995 Official Factory Repair Manual page 2889

On Board Diagnostic (OBD) program
Rapid data transfer
Select function XX
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.01.2
HELP
Basic setting, initiating
Note:
The basic setting should be initiated after
performing the following repairs:
Replacing engine
Replacing Engine Control Module (ECM)
Replacing or altering throttle valve
Adjusting throttle valve (setting idle speed).
Replacing Throttle Position (TP) Sensor -
G69-
Altering setting of Throttle Position (TP) Sensor
-G69- (e.g. when adjusting Closed Throttle
Position Switch)
Replacing Transmission Control Module (TCM)
-J217-
- Connect VAG 1551 Scan Tool (ST), enter
address word 02 for "Transmission Electronics,"
and advance Scan Tool program until "Select
function XX" appears in the display
20 .
Indicated on display:
- Press buttons -0- and -4- (to select function 04
"Basic setting").
Note:
Accelerator Pedal must remain in Closed Throttle
Position.
Page 20 of 43
01-39
page 01-
12/6/2004