Volkswagen Passat 1995 Official Factory Repair Manual page 2974

Shift mechanism, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.37.1
Locking cable, adjusting
Note:
Locking cable must only be adjusted in its
installation position.
- Shift selector lever into "1" position.
- Turn ignition key to right ("START" position) and
release.
- Adjust clearance -a- between lever -1- and locking
pin -2- by sliding locking cable casing.
Dimension -a-
- Tighten locking cable anchorage screw in this
position.
Tightening torque: 6 Nm (53 in lb).
- Shift selector lever into "P" position and turn
ignition key to end ("OFF") position.
- Remove ignition key.
It must only be possible to remove ignition key
with selector lever in "P" position.
It must not be possible for selector lever to be
shifted out of "P" position.
Page 25 of 25
0.7 mm (0.028 in.)
37-25
12/6/2004