Rear axle, servicing (four wheel drive vehicles)
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.SU01.42.3
Fig. 12
Mounting bracket and final drive carrier,
removing and installing
Remove and install complete
When assembling mounting bracket and final drive
carrier away from the vehicle, make sure parts are
correctly located relative to each other.
It is essential that the bonded rubber mounting is
installed stress free in the vehicle.
Tightening torque -A- 45 Nm (33 ft lb)
Fig. 13
Final drive bonded rubber bushing,
pressing in and out
No specific installation position
Insertion depth: flush with lower edge (arrow)
-B- 65 Nm (48 ft lb)
-C- 85 Nm (63 ft lb)
-D- 85 Nm (63 ft lb)
Page 12 of 13
42-44
12/7/2004