Volkswagen Passat 1995 Official Factory Repair Manual page 2848

Repair instructions
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.00.4
Locking elements
Do not overstretch circlips; replace if
necessary.
Circlips must be properly seated in the
grooves.
Nuts, bolts
Nuts and bolts for attaching covers and
housings must be loosened and tightened
evenly, in an alternating pattern.
Do not distort particularly sensitive parts, e.g.
valve body, and loosen or tighten diagonally in
stages.
Tightening torques listed apply to unoiled nuts
and bolts.
Threads of bolts that are secured by locking
fluid are to be cleaned with a wire brush. Then
insert bolts with AMV 185 100 A1.
Always replace self-locking nuts.
Bearings
Install needle bearings with the inscribed side
(thicker sheet metal) facing the drift.
Lubricate all bearings in transmission with gear
oil before installing. Oil with special care for
measuring friction torque.
Heat the inner races of tapered roller bearings
to approx. 100 C (212 F) before installing.
Do not interchange the inner or outer races
between bearings of the same size.
Page 2 of 4
00-7
12/6/2004