Volkswagen Passat 1995 Official Factory Repair Manual page 2982

Transmission, checking
Main pressure specifications:
If possible, carry out the main pressure test on a chassis dynamometer (rolling road).
Automatic
transmission
096
Main pressure - bar
(psi)
1)
After reconnecting the Solenoid Valve connector, check and erase DTC Memory.
Repair Group 01, On Board Diagnostic
If main pressure deviates from specified values, the following are possible causes and
recommended remedies:
Possible cause
Idle speed too high
ATF pump malfunctioning
Control valve sticking in valve body Replace valve body
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.37.2
Selector lever positions and test conditions
D R
Idle Idle
3.4-3.8 6.5-7.5 (94-
(49-55) 109)
Remedy
Adjust
Check ATF pump replace if necessary
Solenoid Valve connector pulled off 1)
D
Engine Speed (RPM)
approx. 2000 RPM
10.1-11.3 (146-164)
Page 8 of 8
R
Engine Speed (RPM)
approx. 2000 RPM
23.0-24.0 (334-348)
12/6/2004
37-33