Volkswagen Passat 1995 Official Factory Repair Manual page 2952

Shift mechanism, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.AT02.37.1
Selector lever cable, checking and
adjusting
Checking
- Remove selector lever cable combi-bolt from
lever/selector shaft.
- Move selector lever from "P" to "1."
Shift mechanism and selector lever cable
must move freely. If necessary replace
selector lever cable or service shift
mechanism.
Always replace selector lever locking washer at
transmission lever after dismantling.
Adjusting
Selector lever in "P" position
- Loosen selector lever cable combi-bolt on
selector shaft lever.
- Bring selector shaft lever into position "P" on
transmission. Locking lever must engage in park
lock wheel, both front wheels locked.
- In this position tighten selector shaft lever
combi-bolt.
Tightening torque: 25 Nm (18 ft lb)
Page 3 of 25
37-3
12/6/2004