Rear Cover Assy (Pl1.1.30) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.5.8 REAR COVER ASSY (PL1.1.30) Removal

1. Take out the MAIN P/H ASSY.
2. Pressing the tub at the upper edge of the P/H COVER, unhook the O/H
COVER from the REAR COVER ASSY. Then move the O/H COVER
backward to remove it.
3. Remove 6 screws (silver, cup head, 8mm) securing the REAR COVER
ASSY and remove the REAR COVER ASSY.
Disassembly/Assembly/Adjustment
C H E C K
P O I N T
Figure 3-10. REAR COVER ASSY Removal
Disassembly/Assembly Procedures
When installing the REAR COVER ASSY, be sure to fasten
the top 2 screws to secure the both TOP COVER ASSY
and REAR COVER ASSY. Pay special attention to the left
screw. Fasten the screw with the TOP COVER ASSY
securely pressed down so that the rib in the TOP COVER
presses the TOP COVER SWITCH (PL13.1.3) without fail.
When installing the REAR COVER ASSY, be careful not to
get the harness caught.
Revision C
3-16