Adc Sensor Assy (Pl6.1.20) Removal - Epson AcuLaser C8500 Service Manual

Color laser page printer

Hide thumbs Also See for AcuLaser C8500:

Table of Contents

EPSON AcuLaser C8500

3.2.9.4 ADC SENSOR ASSY (PL6.1.20) Removal

1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)

2. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)

3. Remove the TENSION LEVER. (See Section 3.2.11.1.)

4. Remove the INNER COVER ASSY. (See Section 3.2.5.5/Section 3.2.5.6/

Section 3.2.5.7.)

5. Disconnect the ADC SENSOR ASSY connector (P/J81), remove the

harness from the clamp, and pull out the connector (J81) from the hole

through which the harness runs.

NOTE: Be careful not to touch the IBT BELT ASSY or Magnet Roll of the

Developer Assy when performing the following.

6. Remove the E-ring securing the ADC SENSOR ASSY.

7. Slide the ADC sensor to the rear and remove the front of the shaft from the

frame. Then remove the rear end of the shaft from the frame and remove

the ADC SENSOR ASSY from the front.

Securely mount the shaft of the ADC SENSOR ASSY on the

frame to the front and rear of the printer.

Disassembly/Assembly/Adjustment

Disassembly/Assembly Procedures

Figure 3-54. ADC SENSOR ASSY Removal