Epson AcuLaser C8500 Service Manual page 370

EPSON AcuLaser C8500
Waste T Box Nearfull
LED: No effect on LED state.
Explanation: The Waste Toner Box is almost full. (The engine's detection
system calculates the level of waste toner, and generates
this message when the Waste Toner Box is almost full.)
Solution: It is recommended that the Waste Toner Box be replaced
when this message appears (although it is possible to
continue using the existing box until the "Replace Waste T
Box" error occurs).
Perform any of the following procedures to clear the
warning message.
1. Press the Continue button.
2. Perform a Reset operation.
3. Replace the Waste Toner Box with a new one.
PS3 Hard Disk full
LED: No effect on LED state.
Explanation: The optional PS3 module uses the HDD.
The HDD capacity that can be used for PS3 reaches its limit.
Solution: Perform any of the following procedures to clear the
warning message.
1. Press the Continue button.
2. Turn the power off and remove the ROM module.
Depleted Battery
LED: No effect on LED state.
Explanation: The battery life is running out. Users con continue printing,
but preparation for a new battery is recommended. This is
not an after-sales part.
Solution: Press the Continue button to clear the error.
Troubleshooting
Worn Fuser
LED: No effect on LED state.
Explanation: The fuser unit life is coming.
Solution: The fuser unit is one of the service parts; The following
explanation is not explained in the User's Guide.
The fuser unit still can be used, but replacing the fuser unit is
recommended.
The message is cleared by any of the following action.
1. Press the Continue button.
2. Perform a Reset operation.
3. Replace the fuser unit with a new one.
NOTE: For version1.0 (Model code: M12087, IA2905[May 29, 2000]),
this message is not installed. For version1.1 (Model code:
M12808, IA0806[June 8, 2000]), this message is installed.
The IA xxxx code will be shown at the bottom of the status
sheet.
Overview
Revision C
5-18