EPSON AcuLaser C2000 / AcuLaser C1000
4.2.3.7 Rear Cover Removal
1. Remove the Rear Controller Cover. (See "Rear Controller Cover Removal"
on page -145.)
2. Remove 11 screws securing the Rear Cover and remove the Rear Cover.
Figure 4-10. Rear Cover Removal
Among the screws securing the Rear Cover, the bottom one
C H E C K
P O I N T
has a washer. This is to allow electrical continuity between
the coated cover and printer frame.
Disassembly and Assembly
4.2.3.8 Rear Right Cover Removal
1. Remove the Rear Cover. (See "Rear Cover Removal" on page -146.)
2. Remove 4 screws securing the Rear Right Cover and remove the Rear
Right Cover.
As shown in the figure above, one of the screws securing
C H E C K
P O I N T
the Rear Right Cover has a washer. This is to allow
electrical continuity between the coated cover and printer
frame.
Disassembling Procedure
Figure 4-11. Rear Right Cover Removal
Revision E
146