EPSON AcuLaser C8500
3.2.7.8 LOW PAPER SENSOR (PL3.1.18) Removal
1. Remove the UNIVERSAL CASSETTE. (See Section 3.2.6.1.)
2. Remove the FRONT MID COVER. (See Section 3.2.5.2.)
3. Remove 1 screw (silver , cup head, 6 mm) securing the TRAY SENSOR
BRACKET and remove the TRAY SENSOR BRACKET. (See Section
3.2.7.3.)
4. Disconnect the connector (P/J106)
5. Release the hook on the CASSETTE N/P SENSOR from the TRAY
SENSOR BRACKET and remove the CASSETTE N/P SENSOR.
6. Remove 1 screw (gold, tapped, 8 mm) securing the LOW PAPER
SENSOR and remove the LOW PAPER SENSOR.
C H E C K
When installing the LOW PAPER SENSOR, be sure to fit the
P O I N T
peg on the CASSETTE N/P SENSOR with the location hole in
the LOW PAPER SENSOR.
Figure 3-29. LOW PAPER SENSOR Removal
Disassembly/Assembly/Adjustment
3.2.7.9 TRAY NO PAPER SENSOR (PL3.1.9) Removal
1. Remove the UNIVERSAL CASSETTE. (See Section 3.2.6.1.)
2. Remove the FRONT MID COVER. (See Section 3.2.5.2.)
3. Remove CASSETTE N/P SENSOR ASSY. (See Section 3.2.7.7.)
4. Disconnect the connector (P/J107) for the TRAY NO PAPER SENSOR
and remove the harness for the TRAY NO PAPER SENSOR.
5. Release the hooks securing the TRAY NO PAPER SENSOR from the
CASSETTE N/P BRACKET and remove the TRAY NO PAPER SENSOR.
C H E C K
P O I N T
Disassembly/Assembly Procedures
When installing the TRAY NO PAPER SENSOR, make sure
the CASSETTE N/P ACTUATOR stays above the TRAY NO
PAPER SENSOR.
Figure 3-30. TRAY NO PAPER SENSOR Removal
Revision C
3-32