Epson AcuLaser C8500 Service Manual page 156

EPSON AcuLaser C8500
Refer to the followings which explain descriptions used in this chapter.
Regarding "(PL X, Y, Z)" at the end of each heading of removal
sections, it corresponds to the numbers in the part list in Appendix.
Referring to the numbers, you can find the appearance and location
of the parts efficiently.
Directions are described as mentioned below. (See Figure 3-1.)
Front: Front side viewing the printer toward its front side
Back: Rear side viewing the printer toward its front side
Left: Left hand side viewing the printer toward its front side
Right: Right hand side viewing the printer toward its front side
Screws are mentioned with descriptions including "(mounting
location, color, feature, thread part length, and so on)".
The number in drawing corresponds to the step number in the
section.
Fasten the screws in the drawings using a Philips screw driver if no
instruction is given.
If black arrows are shown with numbers, they show the order to act
for the step.
White arrows (FRONT) in the drawings show the front side of the
printer.
Refer to Appendix for the connector (P/J) locations and harness
routings.
The generic term "Developer Assembly" is used for "DEVELOPER
ASSY Y", "DEVELOPER ASSY M", "DEVELOPER ASSY C", AND
"DEVELOPER ASSY K".
The generic term "TONER CARTRIDGE" is used for "TONER
CARTRIDGE Y", "TONER CARTRIDGE M", "TONER CARTRIDGE
C", and "TONER CARTRIDGE K".
Disassembly/Assembly/Adjustment Disassembly/Assembly Procedures
Revision C
3-4