Rear Cover Assembly Removal (Pl1.1.30) - Epson ColorPage EPL-C8000 Service Manual

EPSON EPL-C8000

3.2.4.5 REAR COVER ASSEMBLY Removal (PL1.1.30)

1. Take out the MAIN P/H ASSEMBLY. (See Section 3.2.8.1.)
2. Pressing the tub at the upper edge of the O/H COVER, pull the O/H
COVER down to release the hook attaching the cover to the REAR
COVER ASSEMBLY. Then move the O/H COVER backward to
remove it.
3. Remove 6 screws (silver, cup head, 8mm) securing the REAR
COVER ASSEMBLY and remove the REAR COVER ASSEMBLY.
n When installing the REAR COVER ASSEMBLY, be sure
to fasten the 2 screws at the top to secure both TOP
COVER ASSEMBLY and REAR COVER ASSEMBLY.
Pay special attention to the left screw. Fasten the
screw with the TOP COVER ASSEMBLY securely
pressed down so that the rib in the TOP COVER
presses the TOP COVER SWITCH (PL13.1.3) without
fail.
n When installing the REAR COVER ASSEMBLY, be
careful not to get the harness caught.
Chapter 3 Disassembly and Assembly/Adjustment
Figure 3-9. REAR COVER ASSEMBLY Removal
Revision B
3-13