Epson AcuLaser C8500 Service Manual page 501

EPSON AcuLaser C8500
SETUP LOCATIONS
Provide enough space to operate the printer. (See Chapter 6, Figure
1-7)
Avoid places subject to high temperatures, excessive humidity, low
temperatures, excessively low humidity, and extreme temperature
change.
Avoid places near water lines and outlets, humidifiers, heaters,
sources of fire, places exposed to excessive dust, or where air from
an air conditioner strikes.
Avoid places where volatile or combustible gases are produced.
Avoid places exposed to direct sunlight.
Avoid poorly ventilated places.
Avoid places that are not solid and stable.
Avoid places that are not flat and level.
UNPACKING THE PRINTER
Remove the printer from its packing crate and make sure you have the
correct printer and correct number of accessories. Check the printer for
any signs of damage, etc.
Printer unit (including DRUM CARTRIDGE and UNIVERSAL
CASSETTE)
DRUM CARTRIDGE
TONER CARTRIDGE Y
TONER CARTRIDGE M
TONER CARTRIDGE C
TONER CARTRIDGE BK
Chapter 6 Maintenance
EXIT TRAY ASSY
Power cord
SETUP PROCEDURE
For details, see the "Operating Instructions" manual.
The printer weighs approximately 71.2kg, and
W A R N I N G
requires four people to carry it. Workers should be
careful not to injure themselves when carrying the
printer.
Be sure to grip the handles with both hands when
lifting the printer. Gripping the printer by any part
other than the handles could result in dropping or
equipment damage.
When lifting the printer, bend your knees sufficiently
to avoid hurting your back.
The protective sheet, spacers, and fasteners are
needed when relocating the printer. Be sure to store
them for possible reuse in the future after setting up
the printer.
1. Make sure that all parts packed with the printer are present.
2. Remove the fastening tape from the printer.
3. Remove the fasteners.
4. Mount the EXIT TRAY ASSY on the FUSER ASSY.
5. Remove the protective sheet and mount the DRUM CARTRIDGE
on the printer.
Revision C
6-22