Top Exit Sensor (Pl10.2.12) Removal; Exit Chute Switch (Pl10.2.13) Removal; Drive - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.13.7 TOP EXIT SENSOR (PL10.2.12) Removal

1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
3. Remove the EXIT UPPER ASSY. (See Section 3.2.13.2.)
4. Remove the EXIT LOWER ASSY. (See Section 3.2.13.3.)
5. Disconnect the TOP EXIT SENSOR connector (P/J165).
6. Unhook the TOP EXIT SENSOR and remove.
Figure 3-105. TOP EXIT SENSOR Removal
Disassembly/Assembly/Adjustment

3.2.13.8 EXIT CHUTE SWITCH (PL10.2.13) Removal

1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
3. Remove the EXIT UPPER ASSY. (See Section 3.2.13.2.)
4. Remove the EXIT LOWER ASSY. (See Section 3.2.13.3.)
5. Disconnect the EXIT CHUTE SWITCH connector (P/J166).
6. Unhook the EXIT CHUTE SWITCH and remove.

3.2.14 Drive

Disassembly/Assembly Procedures
Figure 3-106. EXIT CHUTE SWITCH Removal
Revision C
3-92