EPSON AcuLaser C8500
3.2.8.16 REGI RUBBER ROLL ASSY (PL4.4.7) Removal
1. Pull out the MSI/REGI HIGH ASSY.
2. Remove the MSI/REGI HIGH ASSY. (See Section 3.2.8.1.)
3. Remove the MAIN P/H FRAME ASSY. (See Section 3.2.8.6.)
4. Remove the REGI CLUTCH ASSY. (See Section 3.2.8.15.)
5. Remove the REGI RUBBER ROLL BEARING.
6. Remove the E-ring securing the REGI GEAR; remove the REGI GEAR and
REGI RUBBER ROLL BEARING.
7. Pull the REGI RUBBER ROLL ASSY all the way forward, then lift the rear
and remove by pulling out diagonally to the rear.
Disassembly/Assembly/Adjustment
Disassembly/Assembly Procedures
Figure 3-46. REGI RUBBER ROLL ASSY Removal
Revision C
3-42