Drive Motor Pwb (Pl11.1.6) Removal; Process Drive Assy (Pl11.1.10) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.14.5 DRIVE MOTOR PWB (PL11.1.6) Removal

1. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
2. Disconnect the 4 connectors (CN1, P/J48, P/J49, P/J50) of the DRIVE
MOTOR PWB.
3. Remove the 2 screws (silver, w/collar, 6mm) securing the DRIVE MOTOR
PWB, and remove the DRIVE MOTOR PWB from the 2 MOTOR PWB
SUPPORTS.
Figure 3-111. DRIVE MOTOR PWB Removal
Disassembly/Assembly/Adjustment

3.2.14.6 PROCESS DRIVE ASSY (PL11.1.10) Removal

1. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
2. Remove the HVPS. (See Section 3.2.16.2.)
3. Disconnect the 2 connectors (P/J51, P/J52) of the PROCESS MOTOR
ASSY, and free the harness by removing from the clamp.
4. Remove the 5 screws (black, w/collar, 8mm) securing the PROCESS
DRIVE ASSY, and remove the PROCESS DRIVE ASSY.
C H E C K
P O I N T
Disassembly/Assembly Procedures
Align the positioning boss of the printer frame with the
positioning hole of the PROCESS DRIVE ASSY when
mounting.
Figure 3-112. PROCESS DRIVE ASSY Removal
Revision C
3-96