Operating The Diagnostics Commander; Starting Up The Diagnostics Commander; Communications Connection - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

4.2.4 Operating the Diagnostics Commander

4.2.4.1 Starting Up the Diagnostics Commander

[Procedure]
1. Connect the Diag tool with the printer.
2. Turn ON the power supply of the printer.
3. Launch Windows 95, and select [Program (P)]-[Tsubaki Service
Commander V*.**]-[TSCV*] from the "Start menu."
4. To quit the diagnostics commander, click on the [Close] button.

4.2.4.2 Communications Connection

[Procedure]
1. Click on the [Manual] tab or [Auto] tab according to what you want to
send.
2. Click on the [Connect] button to connect the communications port.
3. Click on the [Sync] button to establish communications.
NOTE: Clicking on the [Service] tab establishes communications.
NOTE: When exiting the [Manual] tab, or [Auto] tab, disconnect
communications by clicking on the [Disconnect] button.
Chapter 4 Diagnostics
Figure 4-5. Window when the [Manual] tab is selected.
Revision C
4-11