Frame; Deve. Tie Plate (Pl12.1.3) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.15 Frame

3.2.15.1 DEVE. TIE PLATE (PL12.1.3) Removal

1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
3. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
4. Remove the TENSION LEVER. (See Section 3.2.11.1.)
5. Remove the INNER COVER ASSY. (See Section 3.2.5.5/Section 3.2.5.6/
Section 3.2.5.7.)
6. Remove the EXIT UPPER ASSY. (See Section 3.2.13.2.)
7. Remove the EXIT LOWER ASSY. (See Section 3.2.13.3.)
NOTE: Be careful not to damage the DEVE. TIE PLATE by getting it caught
on the connector attached to the rear frame of the printer while
performing the following.
8. Remove the 4 screws (black, w/collar, 8mm) securing the DEVE. TIE
PLATE, lift the DEVE. TIE PLATE, and remove.
Disassembly/Assembly/Adjustment Disassembly/Assembly Procedures
Figure 3-117. DEVE. TIE PLATE Removal
Revision C
3-99