P/Regi Roll Assy (Pl4.4.3) Removal; Pre Regi Clutch Assy (Pl4.4.49) Removal - Epson AcuLaser C8500 Service Manual

Color laser page printer

Hide thumbs Also See for AcuLaser C8500:

Table of Contents

EPSON AcuLaser C8500

3.2.8.13 P/REGI ROLL ASSY (PL4.4.3) Removal

1. Draw out the MSI/REGI HIGH ASSY.

2. Remove the MSI /REGI HIGH ASSY. (See Section 3.2.8.1.)

3. Remove the MAIN P/H FRAME ASSY. (See Section 3.2.8.6.)

4. Remove the PRE REGI CLUTCH ASSY. (See Section 3.2.8.14.)

5. Remove the BEARING 8.

6. Remove the E-ring fixing the MSI-1 GEAR and remove the MSI-1 GEAR,

clip, and BEARING 8.

7. Lifting up the front part of the P/REGI ROLL ASSY, slide the P/REGI ROLL

ASSY forward to release the rear end, and remove the P/REGI ROLL

ASSY by pulling it out to the upper rear.

Figure 3-43. P/REGI ROLL ASSY REMOVAL

Disassembly/Assembly/Adjustment

1. Pull out the MSI/REGI HIGH ASSY.

2. Remove the MSI/REGI HIGH ASSY. (See Section 3.2.8.1.)

3. Remove the MAIN P/H FRAME ASSY. (See Section 3.2.8.6.)

4. Disconnect the connector (P/J95).

5. Remove the E-ring securing the PRE-REGI CLUTCH and remove the

PRE-REGI CLUTCH.

Disassembly/Assembly Procedures

Figure 3-44. PRE REGI CLUTCH ASSY Removal