Warning Message - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

5.1.4.3 Warning Message

Warning errors have no effect on printer operation.
Menus Locked
LED: No effect on LED state.
Explanation: Panel setting change was attempted despite "Panel Lock" is
effective in EJL.
Solution: Press the Continue button.
PS3 Hard Disk full
LED: No effect on LED state.
Explanation: When a HDD unit is used for PS3, the area for PS3 has
reached the limit.
Solution: Press the Continue button or reset the printer.
Collate was disabled
LED: No effect on LED state.
Explanation: There is not enough memory to save a whole 1-job data
when copy is designated. The warning message appears during the 1st copy.
Solution: Press the Continue button. Adding optional memory is
recommended.
Check Paper Size
LED: No effect on LED state.
Condition: "Size Ignore" in the "Config" menu = Off
Explanation: The selected paper size (PAGE SIZE) and the size of the paper
fed do not match. If this error does not occur when the paper
is fed from the paper tray, the value for MP tray size in the
Troubleshooting
printing menu is replaced with the value for the Page Size.
Depending on the paper sizes, the printer may not be able to
detect paper size mismatches and this warning will not be
displayed.
When this warning occurs, be sure to check if any pages (of
the wrong size) were printed before the printer detected the
paper size mismatch.
Solution: Press the Continue button to clear the error.
Time Exceeded
LED: No effect on LED state.
Explanation: Paper was forcibly output blank as the print data did not arrive
within the specified time (set on the engine side) even though
the paper was pre-fed.
Solution: The printer attempts printing again using the same data. If the
same problem occurs, the printer ejects the pre-fed paper and
continues to print with the next data. Perform any of the
following to clear the message.
1. Press the Continue button.
2. Perform a "Reset" operation.
Overview
Revision C
5-15