Roll Assy (Pl10.2.6) Removal; Fuser Fan-1 (Pl10.2.15) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500
3.2.13.5 EXIT-3 ROLL ASSY (PL10.2.6) Removal
1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the 2 front/rear E-rings securing the EXIT-3 ROLL ASSY.
3. Remove the SPUR GEAR, EXIT FRONT BEARING, and EXIT REAR
BEARING.
4. Remove the EXIT-3 ROLL ASSY.
Figure 3-103. EXIT-3 ROLL ASSY Removal
Disassembly/Assembly/Adjustment

3.2.13.6 FUSER FAN-1 (PL10.2.15) Removal

1. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)
2. Remove FRAME CLAMP-PS.
3. Disconnect the FUSER FAN-1 connector (P/J111B), and free the harness
by removing it from the clamp.
4. Spread the hook on the frame that secures FUSER FAN-1, and remove
FUSER FAN-1.
C H E C K
P O I N T
Disassembly/Assembly Procedures
Mount so that the manufacturer's label on the surface of the
FUSER FAN faces outside.
Figure 3-104. FUSER FAN-1 Removal
Revision C
3-91