Ibt Belt Assy (Pl8.2.2) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.11.7 IBT BELT ASSY (PL8.2.2) Removal

1. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
2. Remove the TENSION LEVER. (See Section 3.2.11.1.)
3. Remove the IBT INNER COVER ASSY. (See Section 3.2.5.6.)
4. Remove the FUSER ASSY. (See Section 3.2.12.1.)
5. Remove the BELT CLEANER ASSY. (See Section 3.2.11.3.)
6. Remove the 2ND BTR ASSY. (See Section 3.2.11.4.)
7. Remove the MSI/REGI HIGH ASSY. (See Section 3.2.8.1.)
NOTE: Be careful not to touch the surface of the IBT BELT with you hands
while performing the following steps.
NOTE: Spread paper on the frame below the IBT BELT ASSY without getting
dirty while performing the work.
8. Remove the TRANSFER HIGH ASSY. (See Section 3.2.11.2.)
NOTE: Stand the TRANSFER HIGH ASSY while performing the work while
performing the following.
9. Mount the TENSION LEVER, and lift the PUSH IN LEVER while turning.
10. Spread the arms securing the PUSH IN SHAFT of the TRANSFER ASSY
to the left/right, and remove the PUSH IN SHAFT.
11. Turn the TENSION LEVER, lift the arm to which the PUSH IN SHAFT is
attached, and remove the TENSION LEVER.
12. Disconnect the TR0 SENSOR connector (P/J57).
13. Remove the 2 screws (rear) (black, w/collar, 8mm) securing the IBT R/H
RAIL and IBT L/H RAIL.
14. Remove the 2 screws (front) (black, w/collar, 8mm) securing the IBT R/H
RAIL and IBT L/H RAIL, and remove the IBT R/H RAIL, the IBT L/H RAIL
and COLLAR.
Disassembly/Assembly/Adjustment
<<Continued on the following page>>
Disassembly/Assembly Procedures
Figure 3-73. IBT BELT ASSY Removal - 1
Revision C
3-67