EPSON AcuLaser C8500
8. Turn the ROTARY FRAME ASSY and remove the screw (silver, M4,
22mm) securing the Developer Assy. Align with the hole in the front of the
frame, insert a screwdriver into the hole, and remove the screw.
NOTE: Be careful not to touch the Magnet Roll, etc., of the Developer Assy
while performing the following.
NOTE: At this point the ROTARY LATCH ASSY has been dismounted. Be
aware that the ROTARY FRAME ASSY can turn when the following
step of the procedure.
NOTE: After removing, be sure to lay the Developer Assy in its horizontal
position in a safe place.
9. Slide the Developer Assy forward, lift from the front and remove the
Developer Assy.
Disassembly/Assembly/Adjustment
A D J U S T M E N T
R E Q U I R E D
C A U T I O N
Figure 3-62. DEVELOPER ASSY Removal - 3
Disassembly/Assembly Procedures
After mounting, be sure to make the adjustment as
described in Section 3.3.2 "Development".
After mounting, enter the maintenance mode to reset the
counter (Development Clear) for the replaced color of the
Developer Assy. (For details, see Chapter 6.)
Revision C
3-56