Epson AcuLaser C8500 Service Manual page 365

EPSON AcuLaser C8500
When "Size Ignore" in the "Config" menu = Off and
"Auto Cont" in the "Config" menu = Off, the printer will
automatically override the paper mismatch error after a
specified period of time passes a print on paper form the
paper source sss.
Print Overrun
LED: On Line = off Continue = blinking
Explanation: The print data is so complicated that the printer cannot
process the data quickly enough.
Solution: When "Auto Cont" in "Config" menu = Off, perform any of
the following:
1. If the printer has enough memory, it will attempt to print
one more time, which may bring up the same error. If there
is not enough memory or if the Print Overrun error recurs,
however, the data for that page will be lost and the printer
will begin processing the next page of data.
2. Reset the printer or perform a warm boot.
3. When "Auto Cont" in "Config" menu = On, the printer will
automatically override the error after a specified period of
time and undergo the same process as described above.
Mem Overflow
LED: On Line = off, Continue = blinking
Explanation: While processing a print job, the printer ran out of memory.
Solution: When "Auto Cont" in "Config" menu = Off, perform any of
the following:
1. Press the Continue button. The action follows varies
depending on the cause of the error. If the size of the
graphic data has exceeded the buffer size, the printer
ejects the page before the error, ignoring the command
that caused the error. If the cause of the error is a failure
Troubleshooting
in registering the font macro pattern or so, the printer
ignores the bad command and continues to print.
2. Reset the printer or perform a warm boot. When "Auto
Cont" in "Config" menu = On, the printer will
automatically override the error after a specified period
of time and undergo the same process as described
above.
Invalid HDD
LED: On Line = off Continue = off
Explanation: A problem relating the HDD (Hard Disc Drive) unit has
occurred.
Solution: Turn the printer off and replace the HDD Unit with a valid one.
Invalid AUX I/F Card
LED: On Line = off Continue = off
Explanation: The I/F card currently installed can not be used with this
printer.
Solution: Turn the printer off and remove the card.
Invalid ROM A
LED: On Line = off Continue = off
Explanation: The ROM module in slot A can not be used with this printer.
(The ROM module is write-protected, un-formatted or broken.
If the module is writable and unfromatted, Write Error ROM is
indicated.
Solution: Turn the printer off and remove the card.
Overview
Revision C
5-13