Epson AcuLaser C8500 Service Manual page 65

EPSON AcuLaser C8500
*10: Displayed only when the optional HDD is installed.
*11: Displayed only when the optional PostScript 3 module is installed.
*12: Displayed only when the optional font module is installed to the optional ROM
DIMM socket.
*13: Displayed only when Network Menu > Network Interface is set to On at start-up.
*14: Displayed only when AUX Menu > AUX Interface is set to On at start-up.
*15: Displayed only when "Network Config=Yes" or "AUX Config=Yes".
*16: Displayed only when a download font exists.
*17: Displayed only when GLlike mode is selected.
*18: Either is displayed, depending on the font type selected. "Height" is displayed
when a Proportional Spacing font is selected, and "Pitch" is displayed when a
Fixed Pitch font is selected. When a setting for Font Source and Font number is
changed, the both items are indicated until the LJ4 mode is next activated.
*19: This setting menu is displayed only when the Support Mode has been activated
by the special service function at power-on.
*20: This setting menu is displayed only when the Maintenance Mode has been
activated by the special service function at power-on. Always displayed in English
regardless of the Lang setting in the Setup Menu.
*21: Not displayed in the panel and Status Sheet. It can be set in EJL.
*22: Not displayed in the panel and Status Sheet. It can be set in EJL. It is not open to
users.
*23: Not displayed in the panel and Status Sheet. It can be set in EJL or PJL.
*24: This item is display-only and setting value cannot be changed.
*25: STANDBYTIME command in EJL is also supported. The default value is 60
minutes.
*26: When Interface setting is changed, printing on the status sheet for themselves
and status read-back with EJL are immediately reflected. However, it becomes
valid after warm-boot or at power on again.
*27: The setting value depends on the Type-B Level3 I/F board setting.
*28: This is automatically set to "No" after the printer status shifts to "On-line".
*29: Pre-printed paper can be used only in the MSI Tray and it cannot be fed from LC1/
2/3 because of the engine specification.
*30: When LJ4 Menu > SymSet Value is changed to this Symbol set, Font Source =
Resident, Font Number = 0 setting is automatically made, and therefore in order
to print this symbol set, a font must be selected for which the Font Source and
Font Number Value are supported by this symbol set.
Table shows the user setting items that are not included in the SelecType
setting menu.
PRODUCT DESCRIPTIONS
Table 1-28. User Setting Items
Setting items
Printer Name
MFG of the Device ID
MDL of the Device ID
DES of the Device ID
CID of the Device ID
Panel Setting
Setting value Initial value
32-byte character string AL-C8500
32-byte character string (Undefined)
32-byte character string (Undefined)
32-byte character string (Undefined)
32-byte character string (Undefined)
Revision C
Setting method
EJL, PrinterName
command
EJL
EJL
EJL
EJL
1-45