Feed Solenoid (Pl3.1.35) Removal - Epson AcuLaser C8500 Service Manual

Color laser page printer

Hide thumbs Also See for AcuLaser C8500:

Table of Contents

EPSON AcuLaser C8500

3.2.7.4 FEED SOLENOID (PL3.1.35) Removal

1. Remove the REAR COVER ASSY. (See Section 3.2.5.8.)

NOTE: In the following step, the OPTION BRACKET is kept connected to the

printer body with a harness. Therefore, do not move the OPTION

BRACKET away from the printer.

2. Remove 2 screws (silver, cup head, 6mm) securing the OPTION

BRACKET and separate the OPTION BRACKET from the printer body.

NOTE: When installing the OPTION BRACKET in the following step, be

careful with its sharp edges. Remove the bracket if necessary.

3. Remove the screw (silver, cup head, 6 mm) securing the FEED

SOLENOID and remove the FEED SOLENOID.

Make sure the protrusion on the FEED GEAR and the arm

of the FEED SOLENOID are securely engaged.

After installing the solenoid, check that the notch of the

FEED GEAR rests on the arm of the solenoid. (The FEED

ROLL comes to the top.)

Disassembly/Assembly/Adjustment

Disassembly/Assembly Procedures

Figure 3-25. FEED SOLENOID Removal