Waste Toner Sensor (Pl6.1.42) Removal; Toner Box Sensor (Pl6.1.43) Removal - Epson AcuLaser C8500 Service Manual

EPSON AcuLaser C8500

3.2.9.6 WASTE TONER SENSOR (PL6.1.42) Removal

1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
3. Remove the ROS ASSY. (See Section 3.2.9.3.)
4. Remove the XL RAIL ASSY. (See Section 3.2.9.5.)
5. Free the XL RAIL ASSY by unhooking and removing the harness from the
clamp.
6. Disconnect the WASTE TONER SENSOR connector (P/J88).
7. Unhook the WASTE TONER SENSOR from the XL RAIL and remove the
WASTE TONER SENSOR.
C H E C K
Be careful not to allow slack in the harness when mounting.
P O I N T
Figure 3-56. WASTE TONER SENSOR Removal
Disassembly/Assembly/Adjustment

3.2.9.7 TONER BOX SENSOR (PL6.1.43) Removal

1. Remove the TOP COVER ASSY. (See Section 3.2.5.4.)
2. Remove the DRUM CARTRIDGE. (See Section 3.2.9.1.)
3. Remove the ROS ASSY. (See Section 3.2.9.3.)
4. Remove the XL RAIL ASSY. (See Section 3.2.9.5.)
5. Free the TONER BOX SENSOR harness by removing it from the clamp.
6. Disconnect the TONER BOX SENSOR connector (P/J83).
7. Unhook the TONER BOX SENSOR from the XL RAIL and remove the
TONER BOX SENSOR.
C H E C K
P O I N T
Disassembly/Assembly Procedures
Be careful not to allow slack in the harness when mounting.
Figure 3-57. TONER BOX SENSOR Removal
Revision C
3-52